@fets So far, I have only built the 5x5 board (but the others should be schematically identical). The only issue I have found so far is that I cannot get the ISP port to work. But I have checked and I have an identical setup on the 1.0 board and that worked, so I suspect the programmer is too weak to drive the net on this one. So it is not a board-issue per se, and might only be an issue on the 5x5 board as routing is the most complex on that one due to the size.
@Tommas Hi, now I've posted a device for sale on Tindie, if it's still relevant for you https://www.tindie.com/products/avikmen/usb-rf-gateway-with-stm32-and-nrf24-in-case/
@krisztian
Hi krisztian,
the singleLED board - as its name suggests - features only one LED output. If you want to have a setup with multiple LED strips you need to design a board with multiple outputs. I have already designed a board with 4 outputs, but I haven't built it.
In terms of software you need to register multiple sensors in your program like this:
#define numCh 4 //the number of outputs
const byte ledPins[] = {9,6,5,3};
byte ledLevel[numCh];
boolean ledDimWay[numCh];
//in the setup function request the dim levels from the gateway
for(byte i=0; i<numCh; i++) request(i, V_DIMMER);
//in the presentation function register multiple lights
for(byte i=0; i<numCh; i++) present(i, S_DIMMER);
//if you receive a signal, you need to check for the sensor id
setLED(message.sensor, requestedLevel);
//to set the LED level (function: setLED) you need to use the sensor id to determine brightness and pin
//Fade LED to set level
int delta = (level - ledLevel[child]) < 0 ? -1 : 1;
//Write to LED
analogWrite(ledPins[child], map(ledLevel[child],0,100,0,255));
I will probably publish the whole code once I have built and tested the 4LED controller (i call it "MySensors rainbowLED")
Hope I could help you
ThetaDev
Hi,
for everyone who reads all of this, forget about the last few posts.
I don't know why it works even when the Interrups are masked out on the radio, but it works now.
The error I had occured because of the config of the OrangePi-Gateway.
I removed:
--extra-cxxflags="-DMY_RF24_DATARATE=\(RF24_250KBPS\) -DMY_RF24_BASE_RADIO_ID=\(0x00,0xFC,0xE1,0xA8,0xA8\) -DMY_DEBUG_VERBOSE_RF24"
and wrote:
--extra-cxxflags="-DMY_RF24_DATARATE=\(RF24_250KBPS\) -DMY_DEBUG_VERBOSE_RF24"
Now I think I have an working OrangePi-Gateway without signing but with interrupt enabled.
If there are new problems I will come back here.
The next step for me is to activate signing again and bring the node into homeassistant.