Hello everyone,
Firstly, I apologize for reviving such an old thread, but I find myself in a unique situation and was hoping some of you might be able to help.
I hope everyone's doing well. I have a specific inquiry that I couldn't find a recent solution for. Does anyone here know of a tool to generate "fake" Dooya remote (DC90) RF codes for curtains? I've acquired a few motors without controllers and am trying to integrate them with Home Assistant and Bradlink RF remote. Specifically, I'm searching for a way to generate codes for the Up, Down, Stop, and the "Set" button functions to configure curtain limits.
Any insights or guidance would be immensely appreciated. Thank you so much in advance!
Yes, this is a good idea.
but not with an ethernet switch/hub, only an ethernet crossover cable.
??
https://copperhilltech.com/wt32-eth01-serial-to-ethernet-module-based-on-esp32-for-iot-applications/
Just for reference, as this solution was no yet mentioned:
You could also use a second UART on your controller or a software serial for debuging with the following defines:
#define MY_SERIALDEVICE Serial // Interface for controller connection
#define MY_DEBUGDEVICE Serial1 // Interface for debug output
Regards, Edi
super, once again a few super links, thanks for that
i will go for the easy way. this sketch by boots33 works perfectly.
But before that i will try to understand and learn the steps.
thanks again
branther