<![CDATA[Scetch doesn't want to load into Sensebender Micro]]>Hi All,

I have bought 6 Sensebender Micro's.
I have loaded 3 of them with scetches already and they all work.
This evening I wanted to upload a scetch to #4 and that failed. The error I get is
"Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions."
It is the first time I tried to upload something to this #4. I have tried multiple times. The same scetch can be uploaded to one of the 3 I already use.

I use an FTDI to upload the scetches.Instead of a green and red led blinking quickly, now only a red led blinks a few times before the error message appears.
What could be the problem?

]]>https://forum.mysensors.org/topic/2325/scetch-doesn-t-want-to-load-into-sensebender-microRSS for NodeTue, 21 Jul 2026 04:42:23 GMTThu, 05 Nov 2015 20:54:39 GMT60<![CDATA[Reply to Scetch doesn't want to load into Sensebender Micro on Thu, 05 Nov 2015 21:09:48 GMT]]>Do you have the radio connected during upload?

What does the self-test say?
To start self test connect A0->GND during startup. And have a look at the serial monitor.

]]>https://forum.mysensors.org/post/23978https://forum.mysensors.org/post/23978Thu, 05 Nov 2015 21:09:48 GMT<![CDATA[Reply to Scetch doesn't want to load into Sensebender Micro on Thu, 05 Nov 2015 21:04:24 GMT]]>have you tried to invoke the selftest mode in the sensebender ?

The onboard LED should light up during the selftest.. Also debug info should be dumped to serialport in this mode.

]]>https://forum.mysensors.org/post/23977https://forum.mysensors.org/post/23977Thu, 05 Nov 2015 21:04:24 GMT