@Nca78
Well, for small potted plants, you might have to re-pot the plant. However, the nice benefit that would arise is: no visible sensors, which carries with it very high WAF.
Ok, finally I found the Problem.
I changed the prescaler value of Timer0 becuase I needed a higher PWM Frequenciy.
Unfortuneatly this also affects the millis() function that is used in gw.wait.
It turns out taht with the changed TImer 0 Prescaler 1ms was not 1ms anymore but less. So the gw.wait(750) where only 750ms/64 which is not enough for DS18S20 conversion to take place.
Advantage of this sensor is fast and easy installing by the non qualified personal. The sensor is designed for large agriculture facility with many greenhouses where is needed to be controlled temperature and humidity, the atmospheric pressure is for control the motor of air inlet and outlet. With help of the sensor installed outside the greenhouse provide information about positive/negative pressure inside the greenhouse.
Finlay the software read accurate temp/humid value of the Si7021, and only atmospheric pressure of BMP180, the temperature sensor inside the BMP180 is used only by the sensor itself to provide accurate atmospheric pressure measurements.
The sensor can be used also for home automation, and drone applications where is needed correction of the UAV barometric sensor compared to the ground barometric sensor, also humidity measurement can help the pilot to calculate more accurate flying time.
@hek The capacitor addition seems to be helping. So far 9 hours and all the values are updating as they should YAY!
I'll continue to monitor but i'm hopeful that this is the solution.
In deep Sleep the cunsumption is below 19µA, but i have to send with PA_MAX. On some Windows the open/close frequency is verry high, so the battery is to fast emty.
The CR2032 is good, but i want more "lifetime"
