@HouseIOT Sorry to trouble you, i use a mysensors-wifi-gateway with protocol 2.1.1 , and my homeautomation is home-assistant. I can't use your dimmer in my system.
After read the reference, there need to add V-percentage and V-status in the code, as a newbie , I can't do it myself. So I wondered,can you do me a favor?
Thanks a lot.
@antonholmstedt a pro mini fits if you cut the corners, check out https://forum.mysensors.org/topic/6612/door-sensor-remix-of-some-mys-community-efforts
Hi!
I have the same problem as terxw. allpcb.com is missing the "NC drill date". Unfortunately I am not able to create this on my own. Can anybody upload this file?
Thanks
@yury said in Wall Socket Insertable Node:
Looks cool! Do you have experience with capacities switches? I did not play much with them. afraid to use close to AC interference though...
You need to use a capacitive IC with active shielding, basically you have an extra electrode around your touch electrode and the touch IC will compare capacitive change of the touch electrode with capacitive change from the shield electrode. If the change is due to electrical interference then both electrodes will be changed in a similar way and the IC will not trigger.
@fets So far, I have only built the 5x5 board (but the others should be schematically identical). The only issue I have found so far is that I cannot get the ISP port to work. But I have checked and I have an identical setup on the 1.0 board and that worked, so I suspect the programmer is too weak to drive the net on this one. So it is not a board-issue per se, and might only be an issue on the 5x5 board as routing is the most complex on that one due to the size.