Gateway do not receive info from sensor node



  • Hi guys,

    I feel Im getting closer.

    I have a raspberry Pi 2 that I've installed MyController on. This works fine, I can access it via the browser. I have also wired up an NRF24L01+ module to the GPIO pins on the Raspberry Pi. I've managed to add the Raspberry Pi as a controller in MyController.

    Next step is to be able to send something from a Arduino based sensor node. I have an Arduino Uno, with an NRF24L01 module connected.

    I uploaded the
    "hard_signing_whitelisting_full_debug_nrf24_rsa" sketch and the result was this in the Serial Monitor.

    Starting sensor (RNNNAA, 2.0.0)
    TSM:INIT
    TSM:RADIO:OK
    TSM:FPAR
    TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
    TSM:FPAR
    TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
    TSM:FPAR
    TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
    TSM:FPAR
    TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
    !TSM:FPAR:FAIL
    !TSM:FAILURE
    TSM:PDT

    Seem to fail, but not sure why... any suggestions?


Log in to reply
 

Suggested Topics

  • 3
  • 2
  • 2
  • 24
  • 2
  • 1

0
Online

11.2k
Users

11.1k
Topics

112.5k
Posts