@fets So far, I have only built the 5x5 board (but the others should be schematically identical). The only issue I have found so far is that I cannot get the ISP port to work. But I have checked and I have an identical setup on the 1.0 board and that worked, so I suspect the programmer is too weak to drive the net on this one. So it is not a board-issue per se, and might only be an issue on the 5x5 board as routing is the most complex on that one due to the size.
Hi @tbowmo, do you mind to explain a bit about the design? I'm interested with your design.
I will use these steps for removing voltage regulator, http://goo.gl/CsZaNg
So the design will be battery > external step up regulator (http://goo.gl/PFt99R - to stabilize 3.3v) > vcc pin ?
with these then I can use my first post design?
Thanks
In deep Sleep the cunsumption is below 19ยตA, but i have to send with PA_MAX. On some Windows the open/close frequency is verry high, so the battery is to fast emty.
The CR2032 is good, but i want more "lifetime"