You should not typ "\n"!
It means that you should press enter on your keyboard.
On Linux I saw that I have to send "\r\n" instead of "\n".
"\r\n" (Carriage return, Line feed) is the Windows return, "\n" only the Linux return.
@Chester good point, but I was restarting the arduino and still couldn't get this to work correctly. Also, the missing "end" was just missed out of the paste here, it was in my code.
@fets So far, I have only built the 5x5 board (but the others should be schematically identical). The only issue I have found so far is that I cannot get the ISP port to work. But I have checked and I have an identical setup on the 1.0 board and that worked, so I suspect the programmer is too weak to drive the net on this one. So it is not a board-issue per se, and might only be an issue on the 5x5 board as routing is the most complex on that one due to the size.
Hi,
for everyone who reads all of this, forget about the last few posts.
I don't know why it works even when the Interrups are masked out on the radio, but it works now.
The error I had occured because of the config of the OrangePi-Gateway.
I removed:
--extra-cxxflags="-DMY_RF24_DATARATE=\(RF24_250KBPS\) -DMY_RF24_BASE_RADIO_ID=\(0x00,0xFC,0xE1,0xA8,0xA8\) -DMY_DEBUG_VERBOSE_RF24"
and wrote:
--extra-cxxflags="-DMY_RF24_DATARATE=\(RF24_250KBPS\) -DMY_DEBUG_VERBOSE_RF24"
Now I think I have an working OrangePi-Gateway without signing but with interrupt enabled.
If there are new problems I will come back here.
The next step for me is to activate signing again and bring the node into homeassistant.