I'm very interested by your setup. It has been a shame to have some low voltage power in order to measure power consumption
I hope you can display something soon.
Regards,
Hi,
I finally received the boards from the manufacturer(big thanks to @Seeed-Fusion). I manage to assemble one board by soldering the components and such and...it WORKS(including OTA)! I will post the instructions on openhardware.io project page.
@kimot I am not handling that situation. I'm taking for granted ssr will do his job. Maybe there's some ssr safety topic I'm unaware? Suggestions for a v3.0 are welcome.
About the temperature measuring... I use two sensors. The one in the board protects electronics from temperatures beyond design (60°C). It's near the ssr because the ssr's derating curve is the most limiting condition.
The control sensor is placed in the bottom of the heater. It connects to the board through a 3 pin header connector.
@Sunseeker According to the Connecting the Radio page, D2 is the default pin for the CE signal for the NRF24. If you'd like to use this pin for I2C, you can free it up by assigning a different pin for the CE signal by adding this line to your sketch:
#define MY_RF24_CE_PIN pin
IIRC, all available pins should work for this purpose (D0, D3, D4). Just pick one and if it doesn't work, use one of the other pins. Please make sure to add that line before #include <MySensors.h>.