Hi @berkseo. Thanks for the suggestion, but could you describe in more detail? As for my TODO list, there is already a task to add 485 interface to the gateway. My latest device "xRoom" have this interface.
ps/ Where have you gone?
I have been working on "xRoom" shield. A small announce:
Do you remember the discussion about multinode? So, it will be available soon))
Hello Tilman, this is really a very nice design. I have ordered a pack of PCBs from elecrow, based on your gerber files, and have a few questions:
in your BOM you have listed 5 smd-capacitors and 7 smd resistors, but on the PCB i have solderpads for 6 capacitors and 8 resistors. Can you just explain?
is there a uniflächentaster-model for 2 ways?
i think i have to flash the bootloader first, do you have a tutorial for this, and a sample-sketch for the board?
Thank you very much
@michlb1982
A couple of things, you put the device to sleep so while it's asleep, it won't respond to the commands to change the relays. Since you are combining relays and sensors, you need to keep the unit awake and find a different way to send the sensor data occasionally. For the relay status, read the comments in the sketch. You are saving the relay state and then reading that on startup. You can eliminate all of that code and just set the relay to off in the setup section.
Cheers
Al
Added sketch, which also supports an additional mini PIR sensor. It's what I needed, you can comment to #define out.
Also changed the regulator to a smaller one, which supplies up to 100 milli Amp, which is plenty enough. That way I can keep the circuit smaller on the PCB. Which allows me to create a smaller housing.