@yury said in Wall Socket Insertable Node:
Looks cool! Do you have experience with capacities switches? I did not play much with them. afraid to use close to AC interference though...
You need to use a capacitive IC with active shielding, basically you have an extra electrode around your touch electrode and the touch IC will compare capacitive change of the touch electrode with capacitive change from the shield electrode. If the change is due to electrical interference then both electrodes will be changed in a similar way and the IC will not trigger.
@shabba
Hi, unfortunately I don't have time and patience for doing BOM's on all of my projects but in this case it's not very hard as the external component count is greatly reduced by using the NRF51822 RF SOC which is a PTR5518 module from Aliexpress. Other than that there is the Microchip touch sense controller - MTCH105 and the usual smd resistors(0603) and caps. Other than that you're not forced to use and solder the onboard dc-dc converter so you don't have to worry about those components - you just need to solder the 3V_EN jumper to use the Livolo 3V output coming from the main relays/power supply board.
I'm very interested by your setup. It has been a shame to have some low voltage power in order to measure power consumption
I hope you can display something soon.
Regards,
Qq.