Vera and rpi3 setup that worked for me



  • After looking for days asking and questions in the forums i finally got my rpi3 and vera ui7 setup properly with working inclusion button.
    1.use the master branch
    2. Before you add your ./configure settings ( dont include--my-gateway=ethernet --my-controller-url-address=) or u will prob get ethernet connect error).
    use putty and do sudo nano /home/pi/MySensors/configure
    then scroll down to function detect_machine and change it to match the settings below. link below were i found the info.
    link text

    function detect_machine {
    ...
        case $hardware in
    ...
        BCM2835)
            soc="BCM2835"
            if [[ $machine == "Raspberry"* ]]; then
                local rev=($(detect_rpi_revision))
                if [[ $rev == "a02082" || $rev == "a22082" ]]; then
                    tp="RPi3"
                else
                    tp="Rpi2"
                fi
            fi
            ;;```
    
    

    If the radio is wired properly after you run make and sudo ./bin/mysgw -d you should get a success message like in the tutoriallink text
    3 To get the start/include button to work after you upload the files to vera from link text
    using putty again sudo nano /home/pi/MySensors/examples_linux/mysgw.cpp and add
    #define MY_INCLUSION_MODE_FEATURE after that reboot and it should work. forgot where i found the info.


Log in to reply
 

Suggested Topics

  • 5
  • 6
  • 1
  • 1
  • 10

1
Online

11.2k
Users

11.1k
Topics

112.5k
Posts