LinkSprite Lora Radio Shield support RFM95

  • I have been trying to get the LinkSprite Lora Radio shield with Arduino Uno to work with MySensors with no success.

    Here is a link to the specific shield I am trying to get working with MySensors:

    I have downloaded the latest development branch from Github (2.2-beta) and have configured a Passive Node and GatewaySerial as below.

    Here is my Gateway Serial configuration:

    #define MY_DEBUG
    // Enable and select radio type attached
    #define MY_RADIO_RFM95
    #define MY_DEBUG_VERBOSE_RFM95

    Here is my Passive Node configuration:

    // Enable debug prints
    #define MY_DEBUG
    // Enable passive mode
    #define MY_PASSIVE_NODE
    // Passive mode requires static node ID
    #define MY_NODE_ID 100
    // Enable and select radio type attached
    #define MY_RADIO_RFM95
    #define MY_DEBUG_VERBOSE_RFM95
    #include <MySensors.h>
    #define CHILD_ID 0   // Id of the sensor child
    // Initialize general message
    MyMessage msg(CHILD_ID, V_TEMP);
    void setup()
    void presentation()
    	// Send the sketch version information to the gateway and controller
    	sendSketchInfo("Passive node", "1.0");
    	// Register all sensors to gw (they will be created as child devices)
    	present(CHILD_ID, S_TEMP);
    void loop()
    	// generate some random data

    I see the gateway and passive node each start up and init ok. The passive node send messages every 2 seconds however I never see any messages come through to the gateway.

    One other note, I have been able to successfully get these LoRaSender and LoRaReceiver examples below to successfully send messages to each other, but they are using a different set of libraries.

    The link to these examples is here:
    LoRaSender -
    LoRaReceiver -

    Anyone else out there got the LinkSprite LoraShield working with MySensors or any pointers to help me get past this would be much appreciated.


Log in to reply

Suggested Topics