Newline of debug output



  • Hey when one tries to read the serial output of a gateway/node directly, it doesn't seem to send a correct newline char at the end of a line.

    I tried reading the output of a gateway /dev/ttyUSB0 with:

    picocom -b 115200 /dev/ttyUSB0
    

    But the output looks like:

    0;255;3;0;9;MCO:BGN:INIT GW,CP=RNNGA--,VER=2.1.1
                                                    0;255;3;0;9;TSM:INIT
                                                                        0;255;3;0;9;TSF:WUR:MS=0
                0;255;3;0;9;TSM:INIT:TSP OK
                                           0;255;3;0;9;TSM:INIT:GW MODE
                                                                       0;255;3;0;9;TSM:READY:ID=0,PAR=0,DIS=0
                             0;255;3;0;9;MCO:REG:NOT NEEDED
                                                           0;255;3;0;14;Gateway startup complete.
                 0;255;0;0;18;2.1.1
                                   0;255;3;0;9;MCO:BGN:STP
                                                          0;255;3;0;9;MCO:BGN:INIT OK,TSP=1
    
    

    I have also tried Using minicom and screen. All show the same

    EDIT:
    I found out, that I can use cat if I first set the baudrate correctly:

    stty -F /dev/ttyUSB0 115200
    cat /dev/ttyUSB0
    

    This works, but I wonder what is going on in the case if picocom

    EDIT:
    Okay, I found the solution. I guess its the same for minicom as well.

    picocom -b 115200 /dev/ttyUSB1 --imap lfcrlf
    

    the --imap lfcrlf maps line feed to line feed and carriage return. This then gives the desired formatting.


  • Mod

    If you compile an ethernet gateway, you can use myscontroller to debug


Log in to reply
 

Suggested Topics

19
Online

11.2k
Users

11.1k
Topics

112.5k
Posts