I have published all the documentation in a Github repository. If someone wants to make PCBs, I recommend that you wait a little longer until you receive my PCBs and try them.
@zmatokan said in NModule:
@Nca78 Are you still working on this pcbs? i think it would be great to add a version that supports HiLink 220ac->5dc module on powerboard.
No I'm not working on NModules anymore, I have a few old nodes using atmega/nrf24 but I switched to NRF5 for "basic" nodes now, and to ESP32 for more "advanced" stuff.
NModule was designed for beginner and simple/riskless use, so I don't think adding high voltage option is a great idea, it's better to use an external power supply and connect the output to the powerboard.
New to electronics and progamming.... hence excuse rather dumb nature of my query .. recently purchase the Devduino V2.2 OTA version and am trying to figure out if the device comes pre loaded with the arduino bootloader. ??
Damm I am trying to get this working with a Arduino pro mini ,,but no luck wanted to use it in the car ..
How do you wire the NRF24L01+ ???
N-Channel Mosfet s ??? model number please any help much appreciated
I have tried mosfets >>>irf510n
@michlb1982
A couple of things, you put the device to sleep so while it's asleep, it won't respond to the commands to change the relays. Since you are combining relays and sensors, you need to keep the unit awake and find a different way to send the sensor data occasionally. For the relay status, read the comments in the sketch. You are saving the relay state and then reading that on startup. You can eliminate all of that code and just set the relay to off in the setup section.
Cheers
Al
I'm very interested by your setup. It has been a shame to have some low voltage power in order to measure power consumption
I hope you can display something soon.
Regards,
Qq.