I have published all the documentation in a Github repository. If someone wants to make PCBs, I recommend that you wait a little longer until you receive my PCBs and try them.
I'm very interested by your setup. It has been a shame to have some low voltage power in order to measure power consumption
I hope you can display something soon.
Regards,
Qq.
I have published all the documentation in a Github repository. If someone wants to make PCBs, I recommend that you wait a little longer until you receive my PCBs and try them.
https://github.com/giltesa/SmartHome
@fets So far, I have only built the 5x5 board (but the others should be schematically identical). The only issue I have found so far is that I cannot get the ISP port to work. But I have checked and I have an identical setup on the 1.0 board and that worked, so I suspect the programmer is too weak to drive the net on this one. So it is not a board-issue per se, and might only be an issue on the 5x5 board as routing is the most complex on that one due to the size.
What about a vibration sensor? At least in my kitchen, the fans do produce a slight vibration to the metal roof thing.
They pretty cheap on Ebay, I must try it myself...
@Michael-Link I have been out of touch with MySensors for some time now and looking to slowly get back into it. I created this and a few other boards back in 2018 All of the GERBER files for this are in the "Design Files" tab. Those you should be able to send to JLC PCB or one of the other fab houses and have some made. This was designed to be used with 2 other boards that I designed. There was the processor board and the power supply board. The processor board was designed in a way that I could use a couple different switch boards. This one and a universal multi-switch board that had multiple configurations. If you look here you will see my other boards.