Qu3Uk,
I did get a chance to test with a Fitbit recently. It technically worked, but not all that well. The thing is, the Fitbit only advertises every 2 seconds so latency is a bit high. But worse, its apps really want to be connected to it often to sync; and whenever it's connected, it stops advertising and the detector then can't pick it up.
TommySharp,
At this point I don't plan to modify the board much but having it read environmental sensors would be a cool feature!
For that, would be nice to make little beacons that read sensors and advertise/broadcast the readings every few seconds. Then they could be very low-power, run on coin-cells for months, and could be placed anywhere instead of needing it to be hooked up to USB power like the main board is. Like these: https://sen.se/peanuts/ I'm curious if it could read them.
As for enclosures, I know. I would love to have some nice ones but at this point I'm making too many boards to 3D print enclosures, but too few to afford injection-molding tooling to make a custom case.
@ricorico94 welcome to the MySensors commu ity! All you need to do when switching from raspberry pi gateway to ethernet gateway is change the "hardware" configuration in Domoticz.
However, if you are just starting out, don't use this gateway. It works for MySensors 1.x only. Use the new raspberry pi gateway instead.
@chamroeun-ou said in Integrate with ThingsBoard:
If I use Thingsboard gateway, I will have to deploy Mysensors gateway anyway in order to intercept the incoming RF24 data, right?
Yes
@Eric-Buhring great to hear that you managed to get it working. I have used solution like this (arduino+eth. shield+rf24) for some time.
Now I have switched to esp8266+rf24(version with antenna) as a gateway, it is a cool (and smaller) solution