@mfalkvidd said:
I am using them at 12V so the power would be ~4W. Not too much but still enough to get the sink hot!
The voltage makes no difference. 5A is still 5A.
you are right brain fart
Do you have interest to try OH2 together with MySensors Ethernet Gateway to get working?
I do not have enough force to push developers to make this happen. At the moment there is some problem on this, because full control is not possible. I think that MySensors Serial Gateway is working with OH2, but I don't like to use it. I like to connect my devices into LAN not cabling via old fashioned way using serial wires.
Hi @neelam, welcome to the forum!
The dimmer example should work. If you want to use only the esp8266 with wifi (no nrf/rfm or other radio), you'll also need to add gateway settings from https://www.mysensors.org/build/esp8266_gateway
This is a simple, low-cost and quick project that can get a high spouse acceptance factor.
Mirror
Remove the led strip from the aluminum profiles.
Cut the aluminum profiles and the covers to appropriate length. I used a hacksaw to cut profile+cover at the same time to ensure the got the same length.
Cut the led strips at one of the cut points using a side cutter.
Remove the old wires (they are too short to reach the box) and solder new wires.
Put the led strip back inside the aluminum profile. Note that there is a small grove at the back for the strip, this ensures that the strip is close to the profile to maximize cooling.
Glue the profiles to the mirror. I used slow-curing epoxy.
Electronics box
Drill holes in the project box for the switch (6mm) and the potentiometer (6mm should be enough but was too tight so I used 8mm).
Drill a 4mm hole for the wires to the led strips.
Upload the sketch to the Arduino
Connect the Arduino and the battery packs and put them inside the project box.
Fasten the project box using double-sided tape.
Big thanks to my wife for letting me use the action photo.
I've updated the docs at home-assistant.io with sketch examples. Look at the light example.
https://home-assistant.io/components/light.mysensors/#example-sketch
It's what I used for testing during development. It adds an RGB sensor/actuator also besides a dimmer, but you can just remove any references to rgb in the sketch.
The dimmer slider will only be visible after turning on the light and clicking the entity in the gui to bring up the more info card.
@AWI I discovered it the hard way tonight. Lot of "Unknown sensor type" in my domoticz log.
I have it working by declaring it as a distance, pressure etc. It's really dirty but at least for know I can track my RPMs. I guess I will try to poke around on the domoticz forums this week end to see if there is something cooking on their side.
Thanks!