Gateway - Ethernet stops



  • I got a problem that the Ethernet card sometimes (actually very often) just turns "off", all the leds stops blinking so it looks like dead. If I unlug the networkcable and plug it in again then all leds start to blink again. However I can't ping the IP adress until I have done reset on the Arduino.

    I use one 5v 2A powersupply for 2 Arduino, 2 Radio, 1 Ethernet module and one 433MHz transmitter. Could it be to little with 2A for this? Have
    Anyone else experienced the same or similar problem?



  • @olaeke I would think you may be pushing it. Any way to use a few separate supplies for a short time to see if that helps? If you decide to just upgrade your supply, you may want to put caps on the radios to help stabilize the bus.


Log in to reply
 

Suggested Topics

0
Online

11.2k
Users

11.1k
Topics

112.5k
Posts