Using digital pin 3 on both sketches for the data pin from the Dallas DS.

Thanks - Will give it a go. Just kind of hoped someone might have had the same issue and there was a simple solution that I was missing.

Perhaps I have not been clear enough. The one wire network works perfect;y well. I am having problems connecting that to the arduino and reading it via the MySensors Dallas sketch. I have set up small test with one DS sensor in parasite mode and this is not read either by the same sketch.

When I use the standard One Wire example DS sketch it reads the sensor in parasite mode OK. So I am looking for some help how to reconfigure the MySensors Dallas sketch so it can read a Dallas DS in parasite mode.

Hope you can assist.

Hi there,

I have an existing One Wire network with 10 sensors connected. When I set them up I used Parasite Mode.

I am having some difficulty trying to get the MySensors Dallas Sketch to read the sensors. Has anyone got any tips on changes required to read the sensors in Parasite Mode. The Network was read by a Raspberry Pi but I want to migrate to a Arduino and Mysensors, so I can fire the results via my newly set-up MQTT Gateway to OpenHab.

To change the my network would require a complete rewire so please don't suggest that!!

Look forward to any tips.

cheers,

Ally