Nothing fancy. Got my new ts100 today and I pre-soldered some V10 easyPCBs with 3.3v Arduino pro minis.
The iron is pretty good. It is Louis Rossmann approved. Now I need a good 24V power source to drive this thing.
@sullivan-buchs how did you get 7e1 mode on an uno working?
I have some Energy Meters working with Meter-Bus and the IEC1107 protocol. Couldn't find a proper working software lib for serial communication. I solved the problem using the hardware Serial ports on my Mega.
@flyingdomotic thank you. I also had some problems with some nodes which worked very nice on 2.1.1. When I worked on some of the nodes and updated to 2.3.1 I noticed, that communication wasn't so great anymore.
On first glance this fix works on my plant sensor node. Hope it stays that way now.
Some people are saying with debug on it works and without it, it doesn't maybe the Debug line before the ce(low) does the same thing as your delay.
if (!isTransportReady()) wait(MY_RECONNECT);
your node just needs to be awake to reconnect to the gateway.
I've set MY_RECONNECT to 5000 (5sec).
So far this works for my sleeping battery node.
isTransportReady could also be isTransportOK. depends on the version you are using.
I've found some typos on the serial api page.
S_DIMMER 4 Dimmable device of some kind V_STATUS (on/off), V_DIMMER (dimmer level 0-100), V_WATT
V_DIMMER needs to be V_PERCENTAGE
S_HVAC 29 Thermostat/HVAC device V_HVAC_SETPOINT_HEAT, V_HVAC_SETPOINT_COLD, V_HVAC_FLOW_STATE, V_HVAC_FLOW_MODE, V_HVAC_SPEED
V_HVAC_SETPOINT_COLD needs to be V_HVAC_SETPOINT_COOL