Burned out RPi?

barduino

Hi Folks,

Risking a bit of an off-topic, I was wondering if this community could help on this.

I was using an RPi with a serial gateway connected running mosquitto and openhab fine for more than a month.

Yesterday the raspberry stopped recognizing anything plugged in the USB ports.

Otherwise seems working fine.

I got the dreaded message "usb 1-1-port2: over-current change" with nothing connected to the USB's.

The red light is always on, the green blinks occasionally and the RPi boots normally form the SD card

I'm using a 2 amp "good"power supply.

Has anyone experienced this? Is it solvable?

Thanks

Drcashman

Over the air updates
General Discussion • • ToSa