This board supports 3 different radios (beside the onboard WiFi, ESPnow of the ESP32): RFM69, RFM95, CC1101, so it can be used as mySensors gateway, mysensors node, Homematic etc. and it has a mySX connector.
Hi @chey, no, with the pro minis and MySensors lib I couldn't get less.
Didn't measure with yet another multimeter though...
My battery sensors are working now for about a year and the battery levels are between 65% and 70%.
The sensor furthest from the gateway is at 65% and the 3 others at 70%.
Not bad I think.
https://forum.mysensors.org/topic/11499/checking-mechanical-locked-doors-by-a-battery-based-windows-door-sensor-node
Sensebender ethernet gateway success with help.
Was unable to connect sensebender to Windows 11.
Using a suggesetions and assistance by tbowmo
(you could boot linux off a usb, and check there..)
I used an old rasberry pi with Arduino ide to connect and load the sketch, loaded
Mysensors SAMD and Arduino SAMD board profiles, inital compile errors (clinent.h) but recified this with the help of comments by
bjornhallberg (Sensebender Gateway sketch from 2.3.2 with MySensors SAMD Boards 1.0.6 does not compile with Arduino SAMD Boards 1.8.9. Rolling back to Arduino SAMD Boards 1.8.8).
Used the standard ethernet gateway sketch that I am using with my unsecured nano ethernet gateway. Only changed the ip address and #define MY_RF24_CHANNEL to another channel for this second gateway.
I have not setup signing yet, but that is my intention for my sensebender gateway now the basics are working.
@openhardware-io
Hi: (Please direct to Feanor-Anglin if possible)
I previously ordered some 4RelayDIN PCBs off openhardware.io and got v1.6 PCBs but the info on the site I found is only for an earlier version of the PCB board.
I am trying to build some of the boards but there are additional compomemts on the newer PCB board.
The main one which looks to be a driver IC.
Would you please share the updated information with me or perhaps update the openhardware.io site.
Many thanks, Rod