I have not been home so i am unable to change radios or add capacitors, but what i have done and has worked for 3-4 days now is just adding delays between switching the relays.
Before i would switch 1 off and 1 on at the same time, now i have added 15 seconds between and it is working without issue (fingers crossed)
kopite
@kopite
Best posts made by kopite
Latest posts made by kopite
-
RE: Relay node keeps dropping out
-
RE: Relay node keeps dropping out
Thanks @TimO
Power spike would make sense as there is a mix of 240 and 24VACI am going to put the 240 into another box where my zwave 240 switches are and ill add a capacitor
Thanks
-
Relay node keeps dropping out
Hi
Has anyone experienced problems with relay nodes randomly dropping out and needing a reset?
I have a "sprinkler" node with 6 relays\switches published to mysensor gateway.
it is sitting approx 20-30m from the gw and will work flawlessly for 2-3 days and then just drop out and need a reset.
I was thinking of adding a repeater sensor inbetween? -
Multiple Dallas Temp sensors on different sensors
Hi
Has anyone had an issue adding multiple dallas temp sensors?
Every time I add a new board the old one stops reporting and I still only end up with 1 sensor... -
RE: Tank\Vessel Level
Thanks @jkandasa, that's looks exactly what I am after.
Does this code integrate to the various controllers without issue?
I am running Vera & Domoticz -
Tank\Vessel Level
Hi
I would like to propose a tank\level sensor using an HC-SR04 ultrasonic Distance sensor
Node would return a % based on a set High & Set low thresholds -
RE: Log Translation
im using the latest Beta V2.2439, ive tried Relay, Humidity and Pulse counter
-
RE: Log Translation
All I get from Domoticz is
2015-05-15 17:24:33.161 MySensors: Using serial port: COM5
2015-05-15 17:24:34.657 MySensors: Gateway Ready...
2015-05-15 17:24:45.881 New sensors allowed for 5 minutes... -
RE: Log Translation
@Sparkman , the log is from the serial monitor on arduino IDE?
-
RE: Log Translation
Tried this now with a few sensors and gateways and still get the same result in the serial monitor.....im thinking it is the radio now? possible need a capacitor?