I have not been home so i am unable to change radios or add capacitors, but what i have done and has worked for 3-4 days now is just adding delays between switching the relays.
Before i would switch 1 off and 1 on at the same time, now i have added 15 seconds between and it is working without issue (fingers crossed)

Thanks @TimO
Power spike would make sense as there is a mix of 240 and 24VAC

I am going to put the 240 into another box where my zwave 240 switches are and ill add a capacitor

Thanks

Hi

Has anyone experienced problems with relay nodes randomly dropping out and needing a reset?
I have a "sprinkler" node with 6 relays\switches published to mysensor gateway.
it is sitting approx 20-30m from the gw and will work flawlessly for 2-3 days and then just drop out and need a reset.
I was thinking of adding a repeater sensor inbetween?

Hi

Has anyone had an issue adding multiple dallas temp sensors?
Every time I add a new board the old one stops reporting and I still only end up with 1 sensor...

Thanks @jkandasa, that's looks exactly what I am after.
Does this code integrate to the various controllers without issue?
I am running Vera & Domoticz

Hi

I would like to propose a tank\level sensor using an HC-SR04 ultrasonic Distance sensor
Node would return a % based on a set High & Set low thresholds

im using the latest Beta V2.2439, ive tried Relay, Humidity and Pulse counter

All I get from Domoticz is
2015-05-15 17:24:33.161 MySensors: Using serial port: COM5
2015-05-15 17:24:34.657 MySensors: Gateway Ready...
2015-05-15 17:24:45.881 New sensors allowed for 5 minutes...

@Sparkman , the log is from the serial monitor on arduino IDE?

Tried this now with a few sensors and gateways and still get the same result in the serial monitor.....im thinking it is the radio now? possible need a capacitor?

Still trying to get my 1st sensor communication in Domoticz, can anyone translate the arduino serial log for me?
0;0;3;0;14;Gateway startup complete.
0;0;3;0;9;read: 255-255-0 s=255,c=3,t=3,pt=0,l=0:
255;255;3;0;3;
0;0;3;0;9;read: 255-255-0 s=255,c=3,t=3,pt=0,l=0:
255;255;3;0;3;
0;0;3;0;9;read: 255-255-0 s=255,c=3,t=3,pt=0,l=0:
255;255;3;0;3;

I think it is communicating but will not show up in Domoticz??

Cheers

@kunall , do you have a wiring diagram for this?
I am having some issues with my relay module (but i think this is to do with it being 3.3v)

@AWI - How do i check this?
@Andriej - How do i Assess the node ID?
@hautomate - Only my RPi internals show up in devices

Has anyone had success with Domoticz?
I have added a serial usb gateway and pulse sensor but no devices show up?
I can see in the log the following lines
2015-04-30 21:47:31.646 MySensors: Node: 86, Sketch Name: Energy Meter
2015-04-30 21:47:31.654 MySensors: Node: 86, Sketch Version: 1.0

but i cannot see the device....anyone know how to resolve