How would I go about acquiring some of these?
Best posts made by griffinsaic
Latest posts made by griffinsaic
RE: Keep getting "st=fail" despite both 3.3V regulator and decoupling capacitors
While not involving an Uno, I thought I would share my experience.
I was having a similar issue with my nano serial gateway; not accepting messages or incomplete messages from sensors and/or nothing was working at all. Instead of adding an external power supply, I used a Nano Expansion Sensor shield. This cleaned up the power issues, and makes it easier for me to attach several components.
While not ideal for small for factor, it works. I have not had any further communication issues with the serial gateway. However, I do have issues when the sensor battery voltage drops below a certain level. While I have a multimeter, I have not checked at which voltage. Instead I change the batteries whenever the LEDs get dim.
From my limited experience, power is most likely your issue.
RE: Relay Actuator On/Off Status Reversed
I changed the following to get mine to work. Not sure if it will work for you.
define RELAY_ON 1 // GPIO value to write to turn on attached relay
define RELAY_OFF 0 // GPIO value to write to turn off attached relay
define RELAY_ON 0 // GPIO value to write to turn on attached relay
define RELAY_OFF 1 // GPIO value to write to turn off attached relay
RE: Home Security Motion Trigger Monitor
Thanks for the reply. I am not looking to use an LCD, although that may be the best solution. For now, I plan on creating a simple set of LEDs and buttons.
I have looked over the code, and was wondering which part of the code is retrieving the status of a sensor? What if I have multiple motion sensors, how would I retrieve each unique value?
Home Security Motion Trigger Monitor
I am new to the forum, and appreciate everything all of you have done; especially for someone like me that needs assistance programing.
I am working on a home security/automation project. Additionally, I will focus on irrigation for my garden beds. I am using a combination of Arduino's (MEGA, NANO, and Micro), a Veralite, and plan on providing 9-12v power to all of my nodes. The entire system will run off of solar power battery banks; either 12v or 24v; I have the necessary DC to DC step down converters for 24V.
As part of my security system, I would like to use multiple motion detectors around my property. I have a few motion sensors talking successfully to the Vera, but I would also like to have a separate Arduino that monitors when a motion sensor is triggered, which will be represented by a RGB LED (similar to other LCD display projects, but with LEDs). Let's say I have 10 motion sensors, then I will have 10 different LEDs depicting the status of the triggered state. If the device has not been triggered, then the corresponding led will be green. Once triggered, the led color will change to red and begin blinking, and continue to blink until I acknowledge the trigger; I would like to use a momentary button for the acknowledgement (a button per led). After acknowledging the trigger by pressing the button, the LED will go to solid red. If I press the button again, the led will return to green. I hope this makes sense.
My idea is to have an Arduino that receives/monitors the motion sensor messages and sets the LED status and waits until acknowledgement, all of which is not impacted by the normal interrupts/sleep times occurring on the node/Veralite. Additionally, I want to be able to conduct other automation tasks using the Vera, such as turning on/off lights.
Can someone point me to a forum thread which might get me started? Do I need to develop this separate Arduino monitor, or do you think it can be done on the Vera?