I have everything wired to one arduino nano right now. Using the arduino code on the arduino site for SHT30 the sensor works just fine. Unfortunately I have been getting totally lost in the code so i was hoping that someone might have done this already or have a good start for me. All of the sensors i have going have been using the the code already on the mysensors site with the minor changes needed for my network. The physical wiring, sensor construction, and RF concepts are the easy part for me.

Hello everyone, I am pretty new to this arduino and home automation thing. i have managed to get home assistant to work on a thin client with a few integrations including the mysensors one. i am using an arduino uno ethernet gateway with NRF24L01 radios. They are working great for the few temp sensors and relays i have going. i have gotten them all to work basically by just following the mysensors pages. My question is has anyone gotten a SHT30 temp humid sensor to work using an arduino and this setup. i would like to put this sensor outside as a permanent sensor.