I'm having the same / a simular issue of temperature related readings, but at a different temperature level (for me it must be > 14 degree). I massure the dew point as well (temperature = orange, dew point = yellow). It looks to be more related to water in the air than only to temperature.
@zboblamont have you been finally been able to find a solution?
https://github.com/mysensors/MySensors/pull/1562 switches to using libgpiod instead of the earlier interface. I have not tested it myself but it looks good.
@jaydenlord Probably you do. If you leave the EN floating, electrical noise could cause it to enable or disable randomly.
Some enable pin require a HIGH, some LOW. Connect it to VCC to see if it works more consistently. If it doesn't detect, connect it to GND.
If one of these works, then the part wasn't designed to be in a default state of enable.
Let us know your results (I found this video
OSD
@tnick I know this is an old post, but if it helps you - I've created support for STM32 based on latest STM32duino here. It's currently made to be backward compatible for the existing STM32F1 support, which is what you are struggling. But with a small change you can use the new STM32 HAL support. Let me know if you are interested to give it a try.
The longer term plan is to remove the existing (old) STM32F1 support in favor of the new and more general STM32 support. (If @mfalkvidd agrees ;-))
