Problem with adding new sensor

[jribera]

Hi Everyone,

Can someone help explain why, when adding new sensors the following happens:

In this example i just added a new relay sensor (Arduino light 1:3).

If I then manually delete "Arduino Node 1" everything starts working:

Thanks,

Joseph

[korttoma]

Restarting Vera and refreshing your browser would probably give the same result as deleting the device..

[jribera]

I've tried restarting the vera, my USB gateway and the sensor without luck. In fact if i don't manually delete the "Node 1" sensor my other sensors stop working.

Just curious why this is happening. Other than this bug i can't believe how easy everything was to setup !

[BulldogLowell]

@jribera

try to flash the EEPROM

sometimes you need to reset the radio ID, in my experience

/*
*
* This sketch clears radioId, relayId and routing info in EEPROM 
*
*/

#include <SPI.h>
#include <EEPROM.h>  

void setup()  
{ 
  for (int i=0;i<512;i++) {
    EEPROM.write(i, 0xff);
  }
}

void loop()      
{ 
  // Nothing to do here...
}

[jribera]

@BulldogLowell

Thanks i will try this over the weekend.

I actually found a post from Hek on http://forum.micasaverde.com/index.php/topic,16170.msg158102.html#msg158102

Which says "The -node (or -relay) device is automatically created for every Arduino in your sensor network. "

So its interesting that i'm deleting this yet everything is still working

[jribera]

Manged to fix this buy re-installing all the Vera Plugins. Thanks for everyone's suggestions.