Alarm not triggering?
-
I have a few sensors that i would like to trigger a motor controller.
heres an overview of my setup:
i have a raspberry pi running mycontroller connected through my serial gateway on /dev/ACM0
i have a motor controller to control blinds that register as S_COVER.
i have a light sensor.when the light sensor gets to say 60% for example, i would like to trigger the S_COVER to open. so i go into action board > my led sensor > alarms > add
but it will never trip. my sensor is reading data. it will say 61 percent for example but never trip. What am i missing?
-
@Connor-Rigby What is the notification type are you using?
You should use send payload option and you should point out S_COVER sensor.
Can you elaborate bit more about alarm conditions or it will be good if you put screenshot of alarm definitions.
Which version of MyController are you using?
-
this is my alarm set up.
right now my sensor reports tripped or untripped. for example i want it to activate the motor down when tripped.
im using the latest version but ive tried with alpha 5 also to no avail.
-
@Connor-Rigby you should to add payload, right now it looks blank.
-
omg thank you so much. i dont know how i missed that
