Just to let you know that I solved the issue.
I found a library where you can control the speed and make sure it get to it's position.
You can find it here: https://github.com/netlabtoolkit/VarSpeedServo
I incorporated it in the Mysensor sketch and it works eventhoug it looks like it only goes like 90 degrees but it's enough for me :
#include <MySensor.h>
#include <SPI.h>
#include <VarSpeedServo.h>
// #include <Servo.h>
#define SERVO_DIGITAL_OUT_PIN 3
#define SERVO_MIN 0 // Fine tune your servos min. 0-180
#define SERVO_MAX 180 // Fine tune your servos max. 0-180
#define DETACH_DELAY 900 // Tune this to let your movement finish before detaching the servo
#define CHILD_ID 10 // Id of the sensor child
MySensor gw;
MyMessage msg(CHILD_ID, V_DIMMER);
VarSpeedServo myservo; // create servo object to control a servo
// a maximum of eight servo objects can be created
// Servo myservo; // create servo object to control a servo
// a maximum of eight servo objects can be created Sensor gw(9,10);
unsigned long timeOfLastChange = 0;
bool attachedServo = false;
void setup()
{
// Attach method for incoming messages
gw.begin(incomingMessage);
// Send the sketch version information to the gateway and Controller
gw.sendSketchInfo("Servo", "1.0");
// Register all sensors to gw (they will be created as child devices)
gw.present(CHILD_ID, S_COVER);
// Request last servo state at startup
gw.request(CHILD_ID, V_DIMMER);
}
void loop()
{
gw.process();
if (attachedServo && millis() - timeOfLastChange > DETACH_DELAY) {
myservo.detach();
attachedServo = false;
}
}
void incomingMessage(const MyMessage &message) {
myservo.attach(SERVO_DIGITAL_OUT_PIN);
attachedServo = true;
if (message.type==V_DIMMER) { // This could be M_ACK_VARIABLE or M_SET_VARIABLE
int val = message.getInt();
myservo.write(SERVO_MAX + (SERVO_MIN-SERVO_MAX)/100 * val,255,true); // sets the servo position 0-180
// Write some debug info
Serial.print("Servo changed. new state: ");
Serial.println(val);
} else if (message.type==V_UP) {
Serial.println("Servo UP command");
myservo.write(SERVO_MIN,255,true);
gw.send(msg.set(100));
} else if (message.type==V_DOWN) {
Serial.println("Servo DOWN command");
myservo.write(SERVO_MAX,255,true);
gw.send(msg.set(0));
} else if (message.type==V_STOP) {
Serial.println("Servo STOP command");
myservo.detach();
attachedServo = false;
}
timeOfLastChange = millis();
}