Hello
I'm having some trouble understanding how to get my first node running. First I'm a bit confused on how to read the output. Mainly the fact that things are seemingly named differently between pages. This is how I understand it so far.

s = sensor id			->this sensor id
c = command				->message type
t = message type		->Sub type
pt = payload type		->???
l = length of packet	->size
sg = signed yes or no	->not using

Beyond that if I'm reading the output right, it's trying to get a node id; however, I manualy put one in.

Also what does the first numbers mean? eg 1-1-255-255.
And what the st field means? bc?

The setup
I'm using the DallasTemperatueSensor example modified for the DHT11 temp sensor. The sensor is working.
Some code excerpts

//setup
gw.begin(NULL, 1);
gw.present(2, S_TEMP);
//loop
gw.send(msg.setSensor(2).set(temperature1,1));

The controller is just the serial example
The controller also has a 47uf cap between 3.3v and gnd

Node 1 Output

find parent
send: 1-1-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,st=bc:
temp=21.00	Hum=32.00

Controller Output

0;0;3;0;9;read and forward: 1-1-255 s=255,c=3,t=7,pt=0,l=0,sg=0:
0;0;3;0;9;send: 0-0-1-1 s=255,c=3,t=8,pt=1,l=1,sg=0,st=fail:0

Thank you in advanced.