I done all steps only i skipped gateway type. I did MQTT gateway type and made a new gateway and vola, its working.
Best posts made by Mārtiņš Prūsis
Latest posts made by Mārtiņš Prūsis
RE: openHAB and NRF24 without gateway attachments
Correct, i have MQTT communication between rapsberry and esp8266 nodes without problems, but recently i added NRF24 module to raspberry and created NRF24 arduino node. There is communication between raspberry and NRF24 arduino node through air (see picture). Last five rows messaging door state sg=0:"1;0" (0=open, 1=closed), so i want to have this door state forwarded to MQTT server. Maybe later on info from PIR or temperature sensors.
How can i forward this received state to MQTT?
openHAB and NRF24 without gateway attachments
Im new to all of this stuff but i already like what smart house opportunities can give to everyone.
And heres my story begins: As ESP8266 is power-hungry i went for NRF24. I successfully added NRF24 to my rasp and done everything to have communication with my NRF24 node following this guide , and node code this guide.
So my question:
How can i forward or post NRF24 nodes sensor status to MQTT server? As in used guide - door status.
As i already read there are ways with Ethernet Shield W5100 but is it possible to forward info without gateway?
- Raspberry pi 3 with Openhab & MQTT server & NRF24L01 & MySensors branch
- NRF24L01 node (Arduino Nano)
- couple senors connected to ESP8266 sending info to MQTT server