My first 3D printed PIR enclosure
-
been tinkering away for a little and loving this project.
decided on the need for a nice enclosure for my 1st PIR project, at this stage only PIR.. plan for temp, and any other suggestions... its a screw top, so base will be screwed to ceiling, when batteries need replacing, just unscrew cap and change.
Attached are the STL's for all with access to a printer and keen on giving it a crack... love your feed back, and or sketch with temp and anything else...
PIR_V4_Base.stl
PIR_V4_Top.stl
enjoy
its a
-
Wow,
Good job. The batteries are too big
-
@Ashley-Savage Nice Job... Where are the mounting holes for the base?
-
I should get a 3D printer.
My PIR is just a board at the moment as I've not been able to find a good enough box.
-
4 out of 5
Suggested Topics
-
Pass reset on forum
General Discussion • 16 Apr 2014, 06:49 • Dvbit 17 Apr 2014, 03:28 -
Is there a 3D printable enclosure for RPi 4 w/ serial gateway?
Enclosures / 3D Printing • 30 May 2020, 01:29 • Kikakee 19 Aug 2020, 02:43 -
Please help with rspro itx 3d printer
Enclosures / 3D Printing • 17 Mar 2021, 02:49 • malachite666 15 Nov 2022, 09:19 -
3d hubs alternative?
Enclosures / 3D Printing • 19 Nov 2018, 19:20 • sundberg84 15 May 2022, 00:15 -
Enclosures for SR04, Sparkfun soil moisture and solar panel
Enclosures / 3D Printing • 3 Jul 2022, 15:14 • Green BMS 3 Jul 2022, 15:14 -
How to find the wire combinations in a nema 17 stepper motor with six wires?
Enclosures / 3D Printing • 17 Feb 2025, 05:48 • jack22 17 Feb 2025, 05:48
