My first motion build give error

[TON RIJNAARD]

I am a newby and this is my first build i get this error from the motion sensor.

I use a arduino uno to try this project.

Can some one help me what is wron

Starting sensor (RRNNA-, 2.0.0)
TSM:INIT
TSM:RADIO:OK
!TSP:ASSIGNID:FAIL (ID=0)
!TSM:FAILURE
TSM:PDT
TSM:FPAR
TSP:MSG:SEND 0-0-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
TSM:FPAR
TSP:MSG:SEND 0-0-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
TSM:FPAR
TSP:MSG:SEND 0-0-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
TSM:FPAR
TSP:MSG:SEND 0-0-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
!TSM:FPAR:FAIL
!TSM:FAILURE
TSM:PDT

[mfalkvidd]

@TON-RIJNAARD great that you've gotten started
Is this a combined node+gateway or do you have a separate gateway?
Could you post your sketch?

Node id 0 is reserved for the gateway. If this is a non-gateway node, use an id between 1 and 254.

The basics of the MySensors network (nodes, gateways, etc) is described at https://www.mysensors.org/about/network

[TON RIJNAARD]

@mfalkvidd

Hello, thanks for the very fast reply. The sketch is from the motion sensor.
But i have not the gateway (i am waiting on the nano board).
Must i chance the ID nr in the sketch?

Greatz Ton

[BartE]

@TON-RIJNAARD to preset a node id use this define, where 1 can be a number between 1 and 254 (no duplicates allowed within your network)
#define MY_NODE_ID 1

But if there is no gateway you will keep getting errors, since radio messages will fail

[CurlyWurly]

@TON-RIJNAARD
To test things, you need

1. Device 1 with rf24L01+ radio

• Load "gatewayserial" sketch

1. Device 2 with rf24l01+ radio

• Load motion sketch, but add a line before
  #include <MySensors.h>
  so that it looks like this
  #define MY_NODE_ID 1
  #include <MySensors.h>

Switch on both devices and look at the serial messages from Device 1 (Gateway), When movement is detected, you will see new messages etc

[TON RIJNAARD]

Thanks all for the information i wait that i have my nano and look what happens then.