I modified MyConfig.h file and RFM69 driver to allow you build gateway (ethernet or MQTT) with W5100 ethernet and RFM69 radio modules using SoftSPI bus. You can find it at: https://github.com/gieemek/RFM69_softSPI-for-MySensors-2.1.1
@MiKa
Hi.
oki, in case i'll add some explanation.. I'll be busy for this week but you can simply use the serial gw example from MySensors for getting started, this should work. I didn't need to create a special board in arduino for this board, so if you're using it, you'll need to install&use the mattairtech SAMD21 board definition for the pin mapping.
https://github.com/mattairtech/ArduinoCore-samd
@acb
Hi @acb and others, regarding "Do you know if there is a version of this board that is pad-compatible with the C-versions of these HopeRF RFM69s before I go searching? (Since I believe the C-versions are also pad-compatible with the RFM95sā¦)" - did you find any alternative?
I'm in the same boat looking for an adapter from NRF24 to the footprint of RFM69*C = RFM95/96.
Thanks, Joost
I also have project for mini.
The project have pads for battery, battery protection IC, LIPO charger USB for charging... battery voltage measurements....
But the project is not released yet, because high temperature during charging.
