@acb
Hi @acb and others, regarding "Do you know if there is a version of this board that is pad-compatible with the C-versions of these HopeRF RFM69s before I go searching? (Since I believe the C-versions are also pad-compatible with the RFM95sā¦)" - did you find any alternative?
I'm in the same boat looking for an adapter from NRF24 to the footprint of RFM69*C = RFM95/96.
Thanks, Joost
@kimot I am not handling that situation. I'm taking for granted ssr will do his job. Maybe there's some ssr safety topic I'm unaware? Suggestions for a v3.0 are welcome.
About the temperature measuring... I use two sensors. The one in the board protects electronics from temperatures beyond design (60Ā°C). It's near the ssr because the ssr's derating curve is the most limiting condition.
The control sensor is placed in the bottom of the heater. It connects to the board through a 3 pin header connector.
