Updated the ESP-IDF from 4.4.0 to latest 5.1.1 and rebuild.
Framework updated automatically to framework-arduinoespressif32 @ 3.20004.220825 (2.0.4)
Test with 2 sensors on the same pin : Works fine.
However there are two no blocking error messages:
E (1275) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
Complete startup messages:
163 MCO:BGN:INIT GW,CP=R-NGF---,FQ=240,REL=255,VER=2.3.2
168 MCO:BGN:BFR
169 NM:INIT:VER=1.9-dev
171 NM:INIT:INO=Testcontroller v1.0
174 NM:INIT:LIB VER=2.3.2 CP=R-NGF---
178 NM:BFR:INIT
1310 GWT:TIN:CONNECTING...
1313 GWT:TIN:IP: 192.168.68.28
1317 MCO:BGN:STP
1335 NM:STP:ID=0 M=0
1340 NM:LOOP:RELAY(1):SET t=2 v=0
1359 NM:MSG:SEND(2) t=42 p=2864B875D0013C99
1392 NM:MSG:SEND(3) t=42 p=28920675D0013CB4
E (1275) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
E (1276) gpio: gpio_isr_handler_remove(480): GPIO isr service is not installed, call gpio_install_isr_service() first
1407 NM:STP:HW V=0 F=240 M=49480
1421 NM:LOOP:RELAY(1):SET t=2 v=0
3424 MCO:REG:NOT NEEDED
3426 MCO:BGN:INIT OK,TSP=NA
3429 NM:MSG:SEND(1) t=2 p=0
3968 NM:LOOP:2864B875D0013C99(2):SET t=0 v=22.75
4537 NM:LOOP:28920675D0013CB4(3):SET t=0 v=22.19
4542 NM:MSG:SEND(2) t=0 p=22.75
4545 NM:MSG:SEND(3) t=0 p=22.19
