Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Request RGB control

ajachierno last edited by

Would be nice if there was a simple RGB controller, it doesn't seem like it would be that difficult to implement.
Reply Quote 0
1 Reply Last reply
Sparkman Hero Member last edited by @ajachierno

@ajachierno There's an existing thread discussing this: http://forum.mysensors.org/topic/816/send-color-data-to-sensors. Looks like it's planned for the next release.

Cheers
Al
Reply Quote 0
1 Reply Last reply

2
Posts

1624
Views

Log in to reply

Suggested Topics

Controlling Blinds.com RF Dooya Motors with Arduino and Vera
My Project • • petewill

90

7
Votes

90
Posts

73902
Views

Hello everyone, Firstly, I apologize for reviving such an old thread, but I find myself in a unique situation and was hoping some of you might be able to help. I hope everyone's doing well. I have a specific inquiry that I couldn't find a recent solution for. Does anyone here know of a tool to generate "fake" Dooya remote (DC90) RF codes for curtains? I've acquired a few motors without controllers and am trying to integrate them with Home Assistant and Bradlink RF remote. Specifically, I'm searching for a way to generate codes for the Up, Down, Stop, and the "Set" button functions to configure curtain limits. Any insights or guidance would be immensely appreciated. Thank you so much in advance!
PJON on RS485
Feature Requests • • hypnosiss

4

0
Votes

4
Posts

53
Views

25/25 Програма ChatGPT сказала: It seems like you're exploring the use of PJON with RS485. While RS485 is natively supported in MySensors, using PJON for collision handling can offer some interesting advantages, especially in environments where communication reliability is critical. PJON's collision management may be useful in bus systems like RS485, but it's worth considering whether the added complexity is necessary.
debug serial gateway (homeassistant raspberry py 4)
Feature Requests • • Branther

13

0
Votes

13
Posts

69
Views

Just for reference, as this solution was no yet mentioned: You could also use a second UART on your controller or a software serial for debuging with the following defines: #define MY_SERIALDEVICE Serial // Interface for controller connection #define MY_DEBUGDEVICE Serial1 // Interface for debug output Regards, Edi
"ZHNetwork" a esp-now based mesh network for ESP8266/ESP32 hardware
Feature Requests • • graffiti

1

1
Votes

1
Posts

13
Views

No one has replied
wireless gateway
Feature Requests • • Thomaswortman

1

0
Votes

1
Posts

12
Views

No one has replied
ESP32 Wired (no WiFi)
Feature Requests • • Marcin

4

0
Votes

4
Posts

37
Views

It seems that using an Ethernet PHY (like LAN8720) with the ESP32 in a MySensors setup requires a bit of extra configuration, including initializing the PHY using the ETH.h library and disabling the default Wi-Fi initialization. Interestingly, this setup allows for dual IP addresses, with one for the Ethernet connection and another for Wi-Fi, which can be useful in certain applications.

16
Online

11.7k
Users

11.2k
Topics

113.0k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1