Vera Plus and ESP8266

[korttoma]

@mntlvr I'm not sure what kind of serial chip is on the ESP8266 but Vera can not detect all types of serial chips because there are no drivers installed. FTDI chips should be detected by Vera automatically and then you just need to set the correct serial port settings:

[mntlvr]

Thank you so much yes my 8266 has a ch340 serial chip.
Where did you find your 8266 with FTDI chip on board?
Bob

[dbemowsk]

Vera does not support the CH340. I had a CH340 based serial adapter that I was trying to use when I first got my Vera and I found out that it wasn't supported.

[mntlvr]

So do you have a working serial general on your Vera now and does it use an ESP 8266 or a Arduino Nano

[dbemowsk]

@mntlvr If you are asking me, I run a plain serial gateway.

[mntlvr]

So you are using a Arduino Nano with a FTDI chip?

[dbemowsk]

@mntlvr Well, a pro mini, but close enough. It is a pro mini running an nRF24 network set up as a serial interface. Mine is not actually an FTDI chip, it is a PL2303 which is made by Prolific.

[mntlvr]

How did you get Vera to install the non FTDI chip?

[dbemowsk]

@mntlvr The Vera controllers have a list of supported serial devices. If you look at this page under USB Serial Devices, looking at the chipset column you will see that the FTDI and PL2303 chipsets are the only ones that Vera natively supports. For the 2303 chipsets, some say that they don't work, and others say that manual configuration is needed. Mine luckily just worked with no extra configuration. That list was last modified in 2013 though, so what is supported/works and what doesn't most likely has changed since then.

[mntlvr]

Okay thanks
Well I built a Ethernet board using 1.4.1 library and a W5100 Ethernet board and it worked right off so now I am as curious as heck to make the ESP 8266 work but I still think it has something to do with the newest library. I think I will start out with the Arduino IDE 1.6.4 or something like that and see if that makes a difference. Not very many on this site can help with the issue because they do not have Vera Controllers, so I have to figure this out and just keep trying