New CHILD ID after reprogramming

[Richard van der Plas]

How can i keep from mixing the CHILD id every time of my sensor node?
i defined

#define CHILD_ID 5
#define CHILD_ID_PIR1 0
#define CHILD_ID_DOOR1 1
#define CHILD_ID_TEMP1 2

But the Serial debug shows:

4 TSF:WUR:MS=0
11 TSM:INIT:TSP OK
13 TSF:SID:OK,ID=7
14 TSM:FPAR

Thus having a sensor node where i tell them to be 5 and it is 7 ?

[mfalkvidd]

@Richard-van-der-Plas did you add the defines before including MySensors.h?

[Richard van der Plas]

No i did not :

//define MY_DEBUG
#define MY_RADIO_NRF24
#include <MySensors.h>
#include <OneWire.h> 
#include <DallasTemperature.h>
#define ONE_WIRE_BUS 8

OneWire oneWire(ONE_WIRE_BUS); 
DallasTemperature sensors(&oneWire);
#define CHILD_ID 5
#define CHILD_ID_PIR1 0
#define CHILD_ID_DOOR1 1
#define CHILD_ID_TEMP1 2

#define DOOR_SWITCH 3
#define PIR_INSIDE 2

MyMessage msgPIR1(CHILD_ID_PIR1, V_TRIPPED);
MyMessage msgDOOR1(CHILD_ID_DOOR1, V_TRIPPED);
MyMessage msgTEMP1(CHILD_ID_TEMP1, V_TEMP);
// temp ```

[gohan]

@Richard-van-der-Plas said in New CHILD ID after reprogramming:

#define CHILD_ID 5

actually you have to add #define MY_NODE_ID 5 before the #include <MySensors.h>

[Richard van der Plas]

This post is deleted!

[Richard van der Plas]

@gohan said in New CHILD ID after reprogramming:

#define MY_NODE_ID 5

aha MY_NODE_ID, instead of CHILD_ID