No Inclusion
-
@mntlvr sorry I do not have much experience with MySensors Library version 2.2. My 2 Gateways I run at home use 2.0.0 and 2.1.1. And my test GW (SensebenderGW) is running 2.2.1-alpha since there were some issue using RFM69 on the 2.2 version. Maybe you should try the development version also (2.2.1-alpha)? Unfortunately I ho not have any ESP8266 Gateways at the moment but I can see if I have one laying around so that I can test.
-
@mntlvr I got it from GitHub but it seems like the development version is now 2.3.0-alpha, not sure what has changed since I downloaded it.
-
I found an ESP-07 so I uploaded the ESP8266 WiFi Gateway sketch to it an tested inclusion mode in Vera (MySensors plugin version 1.5) and it seems to work just fine for me. I used esp8266 Community version 2.4.1 in Arduino IDE 1.8.5 and MySensors version 2.2.1 -alpha. I'm really out of ideas why this is not working for you.
-
I am begining to believe it is my version of the ESP 8266 like I said mine is a ESP8266-12E devkit version 1 by nodemcu not just a plain jane version of ESP-8266-12 or 12E but I am have many other problems with mysensors right now , have installed IDE v1.84 and mysensor library 1.4.2 on another computer that has never has Arduino or mysensors on it.
I constructed a 5100 gateway using that version of library and IDE and it works just fine. But I have also built a mysensors realy driver sensor with same equipment and am having nothing but nRF24l01 problems and Pro-Mini problems , it works for awhile like maybe an hour then I get check wires or continue to press reset on pro-mini many times in a row and all of the sudden the sensors comes back to life and then all of the sudden I get a version mismatch and then check wires again. I tried 15 different nRF modules and no difference. Now how can you get a version mismatch when GW and sensors are using same library and all programmed with same computer. I am about to give up on mysensors unless someone out here can help with this,because it makes no sense.P.S.
I can take the very same ESP8266 dev-kit and make a server or client app out of it with no problem so there has to be a very large difference between a 12-E and a dev-kit but I do not see the difference other in the dev-kit already has buttons connected and resistors and built-in serial chip.
Any more ideasThomas? -
I too have "No Inclusions" on my Vera UI5.
I have updated my serial getway to the lastest and re-install the old one back again.
Deleted "Mysensors Plugin - version 1.5" on Vera dashboard and re-install back up.
Replace Arduino boards Pro Mini/Nano and radios with existing working ones.
Update Arduino IDE to the latest 1.8.5
And have been reading this numerous times:
https://www.mysensors.org/controller/vera"Restart the Vera LUUP Engine (Settings->Z-Wave Settings->Advanced->Reload Engine)"
I don't have "Re-load Engine" on my Dashboard.The only thing is I have not upgrade Vera to UI7.
Is UI7 stable now?Any help would be much appreciated.
-
After spending days trying to sort the problem, finally bit the bullet and upgraded MySensors Library, Arduino ide and Vera 3 UI5 to UI7.
Thank God I finally did it.Had to set Serial Port Configuration baud to 115200 and redo MySensors inclusions.
My Serial Gateway and MySensors Plugin are working fine now.Touch wood. :smiley:
