Is it possible to use www.pulse-station.com as a controler ?
I'm probably a rare case but I successfully burn the bootloader (atmel 328p stand alone with slimeNode board) using atmel studio7 with an AVRMK2ISP, flash the mySensors code using arduino IDE and the "nodeManager" libraries succesfully too and everythings appear properly in my HomeAssistant, very nice, I've just give a paypal tips ;o)
But I have no idea why I use this bootloader ??? If I used a nano, I wont change the bootloader ? Is there something better ? It could look stupid but their is no real explain about WHY I must change my bootloader on this page...
I dont know exactly where to post... I'd like to get the Rf code from a remote (in 433Mhz of course) with an arduino to be ebale to simulate this action with a MYS module.
I found only one tutorial about this but it's on Pi...
To be clear this what I'd like to control but without the original remote.
Thanks a lot.