@maltimus - thanks, I can see the picture. frstratingly I have the Vera Edge though!

thanks all. back playing again and have refreshed my nano's with the appropriate sketches.
@maltimus your picture is not available

I've got a nano for the relay sensor node and I'm just not getting it.

codebender.cc allows me to upload both sketches.

I plug the serial gateway into the vera edge device and then.....

I'm sure I've added the mysensor plugin app to the vera but it's not allowing me to do anything - help - I have no hair left to pull out!!

thanks all for your help.

I have a little one - the nano and am happy to make it serial connection into vera edge.

going to spend the weekend reading the sketches to see if and where I need to make changes - if anyone can point me in the right direction, that woudl be even better!

is there a good way to test - I uploaded the GW sketch, and think I've followed the vera add in but it teels me the mysensor device needs configuring and not sure where.

loving the challenge, and appreciating the help!

hello all

I've got a coiuple of raspberrypi's working as cameras. I';ve goit a vera edge turning a light on at sunset and have an arduino nano that I can connect via codebender and make the leds flash!

oh, I have breadboard, female to female wires and a few of the recommended radios - i can at least follow the diagram to connect that radio to the nano!

I'm trying to build a serial gateway to connect to the vera edge and then a remote sensor to control a relay which will turn a light on/off

when I first read through this site, it seemed to have all the sketches ready but now I'm struggling to decipher which one I need to use for the Gateway itself.

any help oin this first part of the journey will no doubt be followed up with thanks and requests for every step of the way...

(feel free to tell me arduino is not for me)