At first I have to say that I am new to the world of MySensors. I learned programming with c and c++, so I thought that this shouldn't be a big thing. But it is...
Arduino IDE : 1.8.1
MySensors Library: 2.1.1
UIPEthernet Library: 2.0.1
Arduino AVR Borads: 1.6.17
Controller: Domoticz on Raspberry Pi 3
Arduino Board: Nano Clone
So, I tried to build my first Ethernet Gateway by following the steps in the Build section on MySensors. But I had a few errors concerning the library versions, so I read a lot in the forum to get it done. I double checkt wireing for about 20 times, tried to fix my problems by using different Board Versions and changed the Ethernet Board (thought maybe it is defect), but no success.
I found out, that I am not able to ping the gateway, even when it says that it is running.
As I thougt the mistake was in the Configuration I decided to use an example sketch of the UIPEthernet library to check if this works (Used sketch: Echo Server). But again the same error. When I am trying to ping the Arduino, it says "target host not reachable".
I think it has to to with the combination of the Arduino IDE and the version of the library.
Is here someone, who has the same combination of hardware and could tell me what combination of Arduino IDE and librarys work?
Any help would be great, I am pretty dejected because nothing works.
Edit: I want to use Signing and Encryption later on the Ethernet gateway, herefor I already bought an Arduino mega an read the step by step guide. I also want to stay at the MySensors library Version 2.1.1.
But at first I need to get the "normal" gateway to work.
Thank You in advance!