I have problems with Orange zero to make it work as a MYS gateway.
What is done:
- take Debian img from https://www.armbian.com/orange-pi-zero/
- added /dev/spidev1.0 using instructions from here: https://www.mysensors.org/build/orange
So I actually see spidev1.0 in ls -l /dev/spidev*
- wired everything up as is described here: https://www.mysensors.org/build/orange
So everything is connected to the spi1 pins.
I used nrf24 with a capacitor and without - same result
- ran commands
sudo modprobe gpio-sunxi
echo "gpio-sunxi" >> /etc/modules
git clone https://github.com/mysensors/MySensors.git
./configure --spi-spidev-device=/dev/spidev1.0 --my-transport=nrf24 --my-rf24-ce-pin=2 --my-rf24-cs-pin=13 --my-gateway=serial --my-serial-is-pty --my-serial-pty=/dev/ttyUSB020 --my-serial-baudrate=115200
sudo make install
sudo systemctl enable mysgw.service
sudo systemctl start mysgw.service
sudo ./bin/mysgw -d
And I see failed logs
mysgw: Starting gateway...
mysgw: Protocol version - 2.2.0-beta
mysgw: MCO:BGN:INIT GW,CP=RNNG----,VER=2.2.0-beta
mysgw: !TSM:INIT:TSP FAIL
Has anyone set it up for Zero?
What am I doing wrong?
Thanks in advance!