i have an issue of which i can find not enough info on to solve it
Made a second Ethernet gateway for my garage in which sensors cannot reach the original gateway (too much isolation). Installed a Powerline adaptor to create a network in the garage which works perfectly. The gateway is assigned to Domoticz and is showing alive (no errors in the log or what so ever).
I first disconnected the first gateway, added the second gateway to Domoticz and added a temp/hum Mysensors sensor. Everything went fine, data was coming through and no errors.
Then disconnected the second gateway and hooked it up in the garage (wired with utp to the Powerline adaptor) and waited for an 'alive' signal in Domoticz. The signal got through and the logs show it is connected to the gateway --> MySensors: connected to: 192.168.0.119:5003
Then connected the first gateway again (data was getting in from all the sensors connected to the first gateway).
When I power up the temp/hum sensor connected to the second gateway, the Arduino monitor shows connection with the gateway (no FPAR errors) and data is being sent out, but no data is coming in via the second gateway in Domoticz. Still no errors in the log.
I found some stories about the channel of both gateways which should be the same/different, but without any luck of people getting it to work.
I'm running latest version of Mysensor (2.3.1) and when testing the sensor without the first gateway connected, it works fine. Both gateways are in server mode and both assigned to a unique ip (which I both can succesfully ping via cmd).
All sensors connected on the first gateway are working flawlessly.
Anyone any idea?
PS: sorry for the long and possibly confusing story