Today I got email, but with some kind of change my subscription instead of unsubscribe. Enough for me.
( can’t upload pic via mobile, Firefox)

@mfalkvidd
Mail is out, you can remove mail address for spamming reasons now

@jkandasa

Any news here? (still have my rfm69 Boards here to check of the range is much better)

@mfalkvidd
Mail is out, you can remove mail address for spamming reasons now

Today I got email, but with some kind of change my subscription instead of unsubscribe. Enough for me.
( can’t upload pic via mobile, Firefox)

@m26872
Maybe offtopic, sry, but:
I have Step up at dht22, so it has 3,3v to operate..

But I am in wrong topic, it should be your first 2aa sensor ( https://forum.mysensors.org/topic/486/my-2aa-battery-sensor )

This is what I built, and with 1mhz it doesn't work (tried with step up 3,3v and without) this wasted me many hours, because I wanted to save energy as much possible with 8mhz its operating well.
Greets from Germany

@wergeld
Same confirmation from my side; 1mhz boot loader doesn't work; dht22 with step up connected does always give NAN. Switching to 8mhz boot loader did the trick.
//@2.2.0-beta

nice idea, nice project, nice documentation, nice result
but i've a problem with the led. this is only HIGH when the arduino boots up for ~2 secs. then set to 0 (LOW).

i adjusted some debugging message to find out, what exactly happens, but am stucking here.. in the loop it goes into slowFlash(), but there nothing is called against the led_pin (because of if (millis() - pulseStart < 100UL))

what am i doing wrong?
why is the led only fired at startup, but not when trapped (manually closed the reed switch for short time to simulate some rain)?
what was the intension of the led? (nothing could be found in description & video of pete)
@petewill I don't see the led in your vid... where is it?