Posts made by musthafa

@mfalkvidd said:

@musthafa is there a reason S_BINARY can't be used for those cases?

Thanks. Didn't look at it. Solved my problem.

Can we have S_SWITCH for Wall switches, door bell switches etc ?

@luizrrocha said:

@musthafa : look on the MySensors forum for the MYSController, install it and you can monitor the messages going to the gateway.

Most likely your declaration of the LED output pin on the MySensors arduino is not correct. I still did not use arduinos as actuators with MySensors so I will probably not be of much help here.

Cheers,

Luiz

In OpenHAB it worked as a dimmer. Later on OpenHAB was stuck and my mobile app was frozen. Then I start discovering Domoticz. If it can be discovered in OH2 why not in Domoticz ?

@luizrrocha said:
Thank you!

Hello, @musthafa .

For installation I used the tutorial at http://www.domoticz.com/wiki/Installing_and_running_Domoticz_on_a_Raspberry_PI. It looks like they changed the tutorial that I used to just a single curl command to install it, although there are complaints about it not working alright. You'll have to try it as I cannot reinstall mine.

Domoticz Installation was straight forward as per their wiki.

Setting up MySensors Gateway is also covered in the wiki : http://www.domoticz.com/wiki/MySensors, very easy. I recommend you go thru the wiki pages as I did, they are a treasure of information, as the manual on www.domoticz.com is outdated though useful.

Good luck.

Luiz

MySensors I tried Ethernet didn't work. Virtual Serial Port worked for me. However I have 1 light (LED Test at PIN 4 of Node) & a DHT sensor. Domoticz only lists the DHT sensor. It doesn't show me the light child.

@luizrrocha said:

Ditto, @Robinek70 !

Thank you, Marcelo Aquino, for your fantastic work .

I have Domoticz, Cacti, Heyu and MySensors Gateway running in a 30 dollars RASPBERRY PI 2, all without a glitch, all talking to each other and hopefully soon will also have Alexa for RASPBERRY PI running there also.

If in doubt, by a RASPBERRY PI and thank people who develop and support it for free instead of complaining all the time.

'nuff said.

Luiz Roberto

Can you please give me the instructions for Domoticz setup?

I have a node with DHT11 sensor and I can see mygsw service is getting messages. How do I connect Domoticz with mysensors ?

I have been following openhab until today and I'm switching to Domoticz now.

@marceloaqno Thank you!

@marceloaqno thank you.

I have already installed OpenHAB 2 on my RPi. Can I install mysgw on to the same RPi ?

@marceloaqno

OpenHab 2

Can I install mysensors on a openhab installed RPi ?