Hi,

First of all love mycontroller. I love particularly that the front end is angularJS (I am a developer using AngularJS on my day to day)

My situation is as follows:

I have an arduino that is hooked up to a 433mhz transceiver. That arduino (through the serial monitor at the moment) takes a bit value and either turns a plug on or off based on the bit value.

My question is:

In the mycontrollers enviroment, how would you add functionality to be able to send these various bit values to the same sensor?

Ideally I would like sections relating to each remote and buttons for on and off?

Is this possible? Or something that I would need to implement myself?

Thanks

-----------------------------UPDATE-----------------------------------------

Ok so my posting to the forum may have been a little bit premature.

For anyone that may be new to this and wanted to know the solution...

In my sketch I registered 4 sensors - one for each remote plug i had.

In my incomingMessage function (which was passed the node id and binary value) I filter through which node I need to be emitting a signal to, and what signal to emit.

Simple as that. If anyone would like the sketch let me know!